Setting up Hardware VPN

This will go through installing the hardware token

If you have one of these tokens, this is how you would install this.

Step 1

Install the EMIS Anywhere Cisco software by clicking here:

https://www.emisnow.com/sys_attachment.do?sys_id=257aa57ddbf3cc10a643d278f4961926

Please note – if you already have this software installed, you will need to uninstall it first then reinstall this.

Make sure the VPN selected is “emis Secure Remote Access”

When you enter your username it must have “@egton at the end” eg “1234OBhatti@egton”

Your password will then be your PIN that you were given when you obtained the token followed by the 8 digits that appear when you press the button on the token.

This will then connect you.

Leave a Reply

Your email address will not be published.